Single Thread U-Nuts are used where a full bearing surface on the lower leg is desired. During assembly, these high-performance U-shaped nuts are placed over the edge of a stamped panel, or through a pre-stamped slot. They are then simply pushed until the rear of the fastener locates against the plastic or metal panel edge or snaps into the clearance hole. U-Nuts are self-retained in screw-receiving position to provide simple, rapid attachment of mating panels. They cannot turn as the screw is driven.
Unit of Measure
Specifications
Finish |
N/A Optional finishes are available. |
Overall Length |
N/A 1.035 in |
Screw Size |
N/A 5/16-18 |
Panel Size |
N/A 0.112 to 0.140 in |
Material Thickness (Decimal) |
N/A 0.028 in |
Impression Center to End |
N/A 0.395 in |
Maximum Hole Center to Edge |
N/A 0.562 in |
Overall Width |
N/A 0.63 in |
Panel Hole Diameter |
N/A 0.375 in |
| Material1 | N/A Heat-Treated Spring Steel |
Applications
Applications |
N/A U-Nuts can be designed into an automatic clothes washer to secure a solenoid and mounting bracket. |
Features and Benefits
Features and Benefits |
N/A
|
Additional Information
Additional Information |
N/A Corrosion presents no problem, as these U-Nuts will not freeze on screw threads. In fact, the U-Nut's impression actually cleans out rust, dirt or paint clots from the screw threads as they are removed. Parts featured on this page will fit screws size 5/16" and larger. If the part you are looking for is not in the standard matrix below, please contact an EFC International Representative. If your part is not manufactured, EFC engineers can design exactly what you need to satisfy your unique applications. |
- 1 Unless otherwise specified.
