Request Information
This RDD Hole Punch for RDD Strain Reliefs punches a mounting hole configured specifically for RDD Strain Reliefs. This tool can be used to punch mounting holes for several different strain reliefs in the RDD Lockit™ family. Those strain reliefs are featured under the "Strain Reliefs for Wire/Cable" section of the "Wiring Management" product category.
Unit of Measure

Specifications

Across Flats

 N/A 0.550 in14.00 mm

Mounting Hole Diameter

 N/A 0.625 in15.90 mm

Draw Stud

 N/A 0.375 in9.53 mm

Maximum Thickness for Mild Steel

 N/A 12 gauge

Features and Benefits

Features and Benefits

 N/A
  • Quick and easy operation requiring only a wrench
  • Can be used to punch mounting holes in: mild steel, aluminum, fiberglass and plastic
  • Design prevents metal distortion during the punching process

Operating Instructions

Operating Instructions

 N/A
  • Drill hole in panel one size larger than the stud of the punch
  • Disassemble punch and insert stud through the hole
  • Install die and backing plate onto shaft then bearing and nut
  • Line up punch shaft to desired position and turn nut until punch goes through the metal
  • Disassemble nut bearing and backing plate and remove the slug from the die
  • Repeat process on next hole
Product Catalog