These 1/2" Power-Seal® Worm Gear Clamps are made of high quality stainless steel. The interlocking "square knot" design will not pull apart. This design enables higher sealing pressure even at lower applied torque ranges, such as installing with a screwdriver. Power-Seal Clamps are general purpose and suited for heater and coolant hoses, as well as air intake & bilge pump lines in corrosive and non-corrosive environments. They are available in a variety of stainless steel grades and finishes with 5/16 slotted hex head screw.
Unit of Measure
Specifications
Screw Material |
N/A 316 Stainless Steel (SS) |
Band and Housing Material |
N/A 316 Stainless Steel (SS) |
Minimum Clamp Size |
N/A 1.875 in48.00 mm |
Maximum Clamp Size |
N/A 5.000 in127.00 mm |
Band Width (Decimal) |
N/A 0.500 in |
Features and Benefits
Features and Benefits |
N/A
|