These Double Tube Cushioned Routing Clamps hold two tubes of the same diameters, and have 2 Bolt Holes. These are available with or without vinyl plastisol (PVC) cushioning, which fully encloses the metal and can not come off during assembly or in service.
Unit of Measure
Specifications
Cushion Color |
N/A Black |
Cushion Material |
N/A Vinyl, 1/32" Thick, applied by dipping, fully encloses the metal and cannot come off during assembly or in service. |
Hole Center to End |
N/A 0.312 in |
Hole Center to End Tolerance (±) |
N/A 0.015 in |
Width Tolerance (±) |
N/A 0.10 in |
Gage (G) |
N/A 0.032 in |
Hole Diameter |
N/A 0.281 in |
Hole Diameter Tolerance (±) |
N/A 0.005 in |
Gap |
N/A 0.031 in |
Gap Tolerance (±) |
N/A 0.31 in |
Tube Diameter |
N/A 0.250 in |
Slot Length |
N/A 0.375 in |
Slot Length Tolerance (±) |
N/A 0.020 in |
Print Reference |
N/A 0.531 in |
Weight |
N/A 1.55 lb |
Material
Material |
N/A
|
Features and Benefits
Features and Benefits |
N/A
Double Tube Routing Clamps with 2 Bolt Holes can be special ordered to accommodate 2 tubes of differing diameters, or more than 2 tubes of the same or differing diameters. Parts listed below are of HD Galvanized Steel, CChem-Treated G90, per ASTM A653/A653M . For ordering alternate options, please contact your EFC International Representative. Inspection note: Ends of legs may not line up if clamp is closed around non-rigid tubing or hose. For inspection, close around a hard mandrel. |
