These Blind Hole Push Mount Cable Ties have a minimum loop tensile strength of 50 LB and are available in Natural Nylon 6/6 or Black Heat Stabilized Nylon 6/6.

These Dart Style Push Mount Cable Ties have a push-mount head that snaps into a 0.250" diameter hole, with a wing design that grips the inside of the panel hole. They allow you to bundle your products and attach the bundle securely to sheet metal, wood, and cast iron. These ties are cost effective quality design, and easily installed. They are made from Nylon 6/6 for high impact and tensile strength. They are self-extinguishing and non-corrosive. Parts shown on this page have a minimum tensile strength of 50 Lbs.

These Dart Type Push Mount Cable Ties have a push-mount head that snaps into a 0.250" diameter hole, with a wing design that grips the inside of the panel hole. They allow you to bundle your products and attach the bundle securely to sheet metal, wood, and cast iron. These ties are cost effective quality design, and easily installed. They are made from Nylon 66 for high impact and tensile strength. They are self-extinguishing and non-corrosive.

Domed Fir Tree Push Mount Cable Ties have a minimum tensile of 50 lbs and a seal. These are a push mount style that fits into a 0.250 (6.35mm) hole size and 0.260 - 0.276 (6.604mm - 7.010) mm) panel range. Simply insert the push mount into the hole then wrap the tie around your wires or cable and insert the tapered end of the tie into the head of the tie and pull through and you have secured your bundle to the panel with one fastener.

Dual Twist Lock Clamps will bundle two sets of wires and cables ranging from 0.200 diameter up to 0.800 diameter. The separation length spans from 0.250 in length up to 1 3/4" apart. Special orders are available in any combination - minimums may apply.

Flexible Cable Clamp Straps with Integrated Mounting Pads have serrated straps and ribbed bases for strong cable retention.

These push mount ties space bundles or harness above your board/application.

Fir tree design grips to the inside of a hole. These cable ties not only allow you to bundle your products, they allow you to attach the bundle securely to your application.

Standoff Push Mount Twist Ties with Tree Base Style 3 fits in a 0.312 diameter (± 0.0003) and fits a minimum panel thickness of 0.250. We offer the standoff lengths starting at 3/16" up to 1 1/4". Bundle diameters starting at 0.200 up to 0.800. You simply open the twist, insert your wires or cables, close the twist and insert the dart type push mount into your predrilled 0.312 hole and your wires or cable are secure in your application. Metric standoff sizes available by special order and may require minimums.

These Tie-On Arrowhead Cable Ties have a maximum bundle diameter of 1-1/8 inches, and are releasable. They push into a 0.250 hole diameter in a 1/16-inch panel range.